How to Install a Pull Out Tap in Your Kitchen

Quick answer

Installing a pull out tap like the MORGAN is a straightforward DIY job if you have basic plumbing tools and follow the correct sequence: prepare the deck, feed the hoses, secure the tap, connect the supply lines, and test for leaks.

Step-by-step installation guide

1. 1. Prepare the mounting hole and deck: Measure the existing hole in your sink or countertop. For most pull out taps, the hole should be at least 35mm. If it's too small, use a hole saw to enlarge it. Clean the surface and remove any old sealant or debris. Check the tap's spec sheet for the exact hole size—guessing can lead to a loose fit or damage the deck.
2. 2. Feed the spray hose and supply lines through the hole: From above the deck, drop the spray hose and the flexible supply lines down through the mounting hole. The hose will have a weight or retraction mechanism attached at the end—make sure it hangs freely below the deck without twisting. If the hose gets twisted, the spray head won't retract fully. Rotate the hose to remove any kinks before tightening.
3. 3. Secure the tap body to the deck: Place the rubber gasket and mounting plate (if supplied) over the hole from above, then slide the tap body into place. From underneath, thread the mounting nut onto the tap shank and tighten it firmly by hand, then use a basin wrench for the final quarter turn. Do not overtighten—brass threads can strip. Overtightening can crack the sink or strip the brass threads. Stop as soon as the tap feels solid.
4. 4. Connect the supply lines to the shut-off valves: Attach the flexible supply lines to the corresponding hot and cold shut-off valves under the sink. Use a wrench to tighten the compression fittings, but avoid over-torquing. Hand-tighten first, then give a quarter turn with the wrench. Cross-threading is common here. Start the nut by hand to ensure it's straight before using a wrench.
5. 5. Attach the spray hose to the tap outlet: Under the sink, connect the spray hose to the tap's outlet port. The connection is usually a quick-connect fitting or a threaded nut. Push or screw it on until it clicks or seats fully. Then slide the weight onto the hose (if not pre-installed) and position it about halfway along the hose length. If the weight is too high, the spray head won't retract fully. Too low, and it may hit the P-trap. Adjust after testing.
6. 6. Test for leaks and retraction: Turn on the water supply slowly and check all connections for drips. Pull the spray head out fully and release it—it should retract smoothly without sticking. If it doesn't, adjust the weight position or untwist the hose. Let the water run for a minute to flush any debris. A small drip at a fitting usually means it needs another quarter turn. If it persists, disassemble and check the washer or O-ring.

Product facts

• MORGAN Pull Out Tap - Blackened Bronze: Solid brass in Blackened Bronze, a rich, almost-black tone with reddish warmth. The pull-out spray head extends for rinsing large pans or filling tall jugs, then tucks neatly back into the spout. The Blackened Bronze finish is durable and resists fingerprints, but the hose and retraction mechanism need careful routing during install to avoid kinks.